FESTSTOFFPUMPEN

Series V1/V2

Slurry pump with long or double shaft and intermediate bearing

areas of application

  • Tunnel construction and civil engineering

    Aerated concrete, Bentonite, cement batching, Chalk slurries, Kaolin, clay, Sand & gravel, Sand industry, Slate, marble, granite, Transport concrete
  • Energy Management

    Ash transport, Coal and coke processing, Condensate, Energy plants & power plants, Flue gas desulphurisation
  • Sugar industry

    Beet pulp, Organic slurries, Washing plants, Wastewater treatment plants
  • Steel industry

    Blast furnaces, Closed cooling run process, Cooling water transport, Fire extinguishing pumps, Hot rolling mills, Process water, Sinter and scale deposits
  • Processing & Mining

    Ceramic, glass cut-outs, Chamber filter press loading, Coal/ ore / phosphates / potash/ bauxite, Fe, Zn, Cu, Ti, Salt, Al, etc., Fibrous slurry, Flotation and foam medium, Heavy mining slurries, Iron oxide production, Slurry and sump pumps, Waste recycling
  • Sand & Gravel

    Extraction, Mineral processing, Water retention, Wet processing
  • Chemical Industry

    Fertilisers, PO4, Foaming suspensions, Pigments, Sediments, soda, Separation, SO4, chloride
V2
NPK150-630_V2
NPK150-630-V2_2

For dry well installation of the pump, the pump hydraulics are sealed on the medium side with a mechanical seal.

For wet well installation of the pump, the bearing is sealed on the shaft side by a mechanical seal and the hydraulics on the medium side with a throttle bushing.

This V series benefits from the modular construction of our pump model series. The hydraulic parts of the V series can therefore be designed in models HPK, NPK, NPW and KB and are available as metallic, as well as elastomer-lined pumps.

Model V1

With this model, the drive shaft is designed as one part. Installation depths up to 2500 mm from the lower edge of the installation plate to the middle of the pump housing can be realised.

This installation type is suitable for wet and dry well installations.

Model V2

In a model V2, the drive shaft is designed in two parts having an intermediate coupling. Due to this design, installation lengths up to 5000 mm from the bottom edge of the installation plate to the middle of the pump housing is possible.

This installation type is suitable for wet and dry well installation.

Lubrication system

Integrated lubrication lines ensure perfect lubrication of the bearings and the shaft seal.

Technical data

PROMOTIONAL CURRENT
up to 2.500 m3/h
Förderhöhe, einstufig
up to 60 m.FI.S
Pumpendrehzahl
up to 1.480 min-1
Anschlussnennweiten
DN32 - DN400
Maximaler Betriebsdruck
10 Bar
Temperatur der Flüssigkeit
70°C
Druckstutzenstellung
beliebig
Korrosionsbeständigkeit bei PH
0 - 14